Removing The Used Lancet:
- Note: This lancing device has an ejection feature, so you do not have to pull out the used lancet.
1. Remove the lancing device cap.
- Remove the cap by turning it counterclockwise and then pulling it straight off of the device.
2. Cover the exposed lancet tip.
- Before removing the lancet, place the lancet protective cover on a hard surface then push the lancet tip into the cupped side of the cover.
3. Eject the lancet.
- Slide the ejection control forward until the lancet comes out of the lancing device.
- Return the ejection control to its back position.
- If the lancet fails to eject properly, cock the device again and then slide the ejection control forward until the lancet comes out.
4. Replace the lancing device cap.
- Place the cap back onto the device; turn clockwise to secure the cap.
- It is important to use a new lancet each time you obtain a blood sample. This will help prevent infection and sore fingertips.
Disposing of the used lancet and test strip:
- Discard the used lancet carefully after each use to avoid unintended lancet stick injuries. Used lancets and test strips may be considered biohazardous waste in your area. Be sure to follow your health care professional’s recommendations or local regulations for proper disposal.
- Wash hands thoroughly with soap and water after handling the meter, test strips, lancing device and cap.
